Dremel Workstation

Contributions from GodspeedDan , Batteryinc71 & RAMjetta

Dremel Workstations are not tight out of the box.

You need to tighten it all up, even the lil brass screws.

If you do not, your plunges will be crooked, and that will ruin your build.

These are the MGB recommended areas to check for tightness. Batteryinc71 shares these photos.

I used rubber bands to help keep the dremel nice a plumb, it was a little bit off.

RAMjetta videos

Assembly

Setup your Dremel Workstation for First Time Quality

Part 1

Part 2

Join the MGB 80% Community

Build your freedom.

https://www.marinegunbuilder.com/forum

MGB FORUM

Support 80% community education

Become a VIP